Gears & Gear Racks

The pinion involves mainly one gear, one galvanized sheet house, and two copper alloy bearing. Its gear is made from the technology of powder metallurgy, and is quenched. The gear has hard surface, and is strong. The gear is located in a galvanized sheet house, and is supported by two copper alloy bearings. This pinion can be easily turned, and has long life time. Its maintenance is very easy.

This is important in all kinds of mechanical transmission parts, tooth surface contact stress and friction under during operation, tooth root bending stress are, sometimes to withstand impact.So the gear has good comprehensive mechanical properties, generally choose forged steel blank.

Raydafon Standard Spline Shafting has been designed to maximize torsional strength and contact area. Raydafon cold rolled spline shafts are made with an even number of teeth and are parallel over two or more teeth. When your project requires mating parts, look no further. For your...

Gear shafts often incorporate counter faces for radial shaft seal rings. Typical for these surfaces is the specification "ground twist-free". The so-called twist on counter faces for radial shaft seal rings (RWDR) can cause leakage. For example, the surface which is produced by turning...

Plastic gearing has been increasing in usage as designers better understand their benefits and limitations. These gears can be produced by hobbing or stamping or, for large-volume runs, by injection molding. Some of the key benefits of plastics in the production of gearing are: Reduced weight...

Our Aluminum series right angle worm gear reducers are designed with metric center distances and quill style motor input flanges which allow users a much greater supply of off-the-shelf standard motor input choices. Metric center distances allow for easy installation into existing applications,...